Electrical charges generated in a thunderstorm discharge to the ground with a current of approximately 150 kA. Lightning-induced surge occurs in the cable and instantly applies high energy to the equipment connected to both ends of the cable. These are also called spikes or transients. The duration of these transients is typically measured in microseconds.
Without adequate lightning surge protection devices, the greatest consequence is the risk to human life. Secondly there is the potential downtime in production and the cost of replacing valuable and sensitive equipment, insurance claims, and increased insurance premiums.
A lightning surge protection device, also known as an SPD, is a shield against surges or transient voltage flowing from the power supply. In other words, it blocks or redirects surge current to the ground instead of passing through the equipment.
Technically, most lightning surge protection devices operate with the help of a Metal Oxide Varistor (MOV). This is basically the link between the SPD’s hot wire and its grounding wire. With a variable electrical resistance, the varistor can adjust the incoming voltage that is either too low or too high.
For example, when it’s too high, the MOV redirects the excess voltage into the grounding wire, letting it dissipate safely.
Then, a normal level of voltage continues to flow through. The MOV essentially acts as a pressure-sensitive valve that only opens when there is too much pressure.
The SPD ensures uninterrupted use of your electrical and electronic equipments while protecting them from overcurrent degradation.
Incorporating the latest technology, our manufactured lightning surge protection devices divert the surge current directly to the ground and limit the overvoltage to expensive equipment.
Each of our products solves a particular challenge:
Our AC power surge protectors such as facility guard, transient limiters, power DIN, and Pro-line are designed for industrial and commercial purposes. Our single line and DC power protection such as coaxial line protectors, transient eliminators, and transient limiters will interface between network equipment and data/signal/telephone lines.
Some of the Patented SPDs of Lightning Eliminators & Consultant Inc include:
- Facility guard
- Transient Limiters (TLX100 & TLX50)
- DC surge protector (TLX 50-DC)
- Hybrid Surge Protectors for Data and Telecom application (TE500)
- Data line protector (DLP)
- Coaxial Line Protector (CLP)
For maximum safety and protection, all surge protection devices should only be installed by a licensed professional that is familiar with the equipment and its use.
No matter the weather, connect with our Lightning Eliminator Surge Specialist and get the best possible solution for your facility.